If it doesn't agree with experiment, it's wrong.

Status
Not open for further replies.
Yes, it does. What is the correct way to explain this deceleration?

Here, I will help you.

If you apply the brakes momentarily you will slow down. This is because the applied force is in the opposite direction of travel and the force is only momentary.

If you apply the brakes continuously you will eventually stop. This is because the applied force is in the opposite direction of travel and the force is continuous.

You really should spend some time here: www.physicsclassroom.com/

OK. You have one thing right. The car can, in fact, be accelerated with a negative vector without changing directions, and without coming to a full stop.

Suppose the governor on the engine were set to produce an acceleration (be careful: not a speed, but an acceleration) of10 m/22. Now suppose you tapped the brakes once every 10 meters. What would you expect your final velocity to be, compared to a car that was accelerating at the same rate, but without the brakes being touched?

(Don't look in the back of the book, you won't learn that way...)
 
I don't need to be an engineer to understand Newton's laws of motion. That's why they are taught to children in elementary school. Even they have the capacity to understand them, and apply them to what they see.

It's obvious to everyone here you don't understand them. Maybe you should go study them, instead of embarrassing yourself on this forum everyday.
 
The force exerted by the Hammer is greater than the resistance of the 3/4 nut so the energy of the blow goes into realign the crystal lattice of the steel allowing the but to absorb the energy as deformation.

Similar to how the towers absorbed the energy as disunification, of structure though connection failures.

Crystal lattice? OK.
 
Easy question, are the gravitational potential and the buildings resistance Equal?

Did the buildings stand for 30 years? Yes. Was the potential energy of the 110th floor known to the designers? Yes. Was it taken into account when determining safety margins? Maybe. Is any of this relevant? No.

Was there a deceleration? No. Should there have been? Yes. That is what matters.
 
No the force is not in the opposite direction, that would be going forward and suddenly shifting into reverse, doing that can snap the engine crank shaft if the clutch drive shaft, and transmission hold.
Applying the breaks merely stops the wheels from rotating, it does not reverse the wheels motion. Friction resistance is the stopping force.

Did I say the wheels reversed? No. I said the direction of acceleration was in the opposite direction of travel. The force applied to the brakes produces a force in the opposite direction of travel.
 
Then why do you keep bringing up his credentials and those of others?

So no peer reviewed papers then? You'd think if someone was so interested in the truth they'd publish a paper in a relevant journal. You do know that's how things work in the technical field don't you?

Irrelevant.

Do you really think an engineer needs to publish a peer-reviewed paper in order to demonstrate an understanding of Newton's laws of motion? I don't think so.
 
Someone doesn't know the difference between "force" and "net force".

A force is something that can be applied in any direction that changes the acceleration of an object.

A net force is the vector sum of all forces acting on an object.

An object will move in the direction of the net force, not in the direction of each individual force.
 
Someone doesn't know the difference between "force" and "net force".

A force is something that can be applied in any direction.

A net force is the vector sum of all forces acting on an object.

An object will move in the direction of the net force, not in the direction of each individual force.

Wow. This is correct. What's your point?
 
Please present your numbers to show by how much. Let me guess, you have no idea, it's just your belief?

You already admitted there was a deceleration.. Post 644.

I admitted no such thing. Acceleration due to gravity is approximately 9.8m/s squared. An object can constantly accelerate at any value without deceleration being involved.
 
Wow. This is correct. What's your point?

Something that "decelerates" won't necessarily go in the opposite direction, unless the deceleration, in this case, is roughly 9.8 m/s/s upwards. And since the collapses took longer than gravity says they should, they obviously decelerated.
 
Did I say the wheels reversed? No. I said the direction of acceleration was in the opposite direction of travel. The force applied to the brakes produces a force in the opposite direction of travel.

The force brakes induce friction to slow the rotating wheels, the car stops only when the braking force is equal to the inertia produced by the cars momentum.
That can't happen in the towers.
 
Something that "decelerates" won't necessarily go in the opposite direction, unless the deceleration, in this case, is roughly 9.8 m/s/s upwards. And since the collapses took longer than gravity says they should, they obviously decelerated.

Wrong.

Absolutely wrong.

The top floors did not decelerate as they fell. The continued to accelerate as they fell.
 
Status
Not open for further replies.

ISF - Join now!

Every member here is approved by hand. No bots, no spam, just people who care about evidence and honest debate.

Membership is free!

Create your free account

Back
Top Bottom