To be honest, I think they're a bunch of lying, stinking weasels who would frame their own grandmothers if they thought it would make them look clever. However, that's beside the point. Are you suggesting that the microsphere produced was much bigger than the material that reacted to produce it? If not, then you need to work on expressing concepts more clearly.
When you put a chip in the DSC, it's because you have selected this chip in the iron rich dust with a needle as i did so many times. And you select it by inspecting the particles with a microscope. So each chip that you isolate and
put in you DSC has been inspected: this is obvious! A chip is always thin! so you can imagine there are very small microspheres embedded in the chip material, some of them visible at the surface, some others invisible , completely hidden in the chip but these must have a typical size smaller than the thickness of the chips.
I'have seen plenty of these very small microspheres, some of them even ejected from the chips at high temperature and it is impossible to make such mistake as to say for sure that these microspheres were produced by molten iron due to the reaction of the chips: at the very least there is no evidence for that. And this is why i do not say that my chips reacted.
But in case of the photographs shown by Jones and co there is absolutely no ambiguity because the diameter of the spheroid is huge compared to the thickness of the chip so you could not have missed them at microscopy inspection before putting them in the DSC .
So i'm sorry to repeat again that their evidence is very strong (and i can see no possibility to ignore this) that it is indeed a reaction that melted iron and produced the microspheres.
If so, then you need to look into the law of conservation of mass-energy.
I think it's possible that some substance in the chip reacted with atmospheric oxygen and produced a spherical particle with a significant iron content.
Impossible for a combustion with air oxygen of a micron sized particle to concentrate enough heat on it to melt iron.
indeed each volume V of combustible needs thousands V of air to react completely thus the heat is released in those thousands V of air instead of V of the chip: hence the density of energy is thousand times less than a thermitic reaction where all the reactives are together already inside the chip. Only the latter allows the
concentration of the heat to melt iron!
ANother possibility is to accumulate heat in time and concentrate it in a given volume as in a coal burning furnace that produces fly ash where indeed iron can fuse (over 1500°C). But this is not the condition inside of a DSC if a microscopic particle burns : the energy does not accumulate but the dissipative effects are instead very fast in the surrounding air and the energy is not concentrated.
I think it's even possible that some combination of chemicals in the debris may have reacted in some thermite-like reaction.
In your dreams!! iron oxyde and Aluminum react in this way if Alu is elemental, and nanoparticles of elemental Alu dont exist in nature: Al is always oxydized in surface bery fast, and for a 40nm particle, this surface is very soon the whole particle itself exposed to oxygen of the air.
This is the only reason i see to really question the presence of a black ship among these truthers who may have falsified the data in order to decredibilize the whole study and i'm surprised that nobody has mentionned this issue here : how could elemental nanoAlu remain activate 7 years after 911: hardly possible without a very efficient coating according the studies i have read on the subject. Or storage in very dry and oxygen depleted conditions...
I think it completely impossible that the reaction observed by Harrit et al was not primarily combustion in atmospheric oxygen, and neither can anyone else who is rational and possessed of at least minimal expertise.
This is where you are completely wrong for the obvious reasons i have just recalled
And I think it completely impossible that any such reaction was in any way even a partial cause of the collapse of the Twin Towers, with the same dependent clause.
Dave
several millimeters of thermite could heat any column by hundreds of degrees because the reaction is fast : so there is not enough time for the heat to escape, and the reaction is fast just because it does not need a huge volume of air around like a combustion.
1200 lbs of TNT divided by the volume of the fireball in the plane crash is still a ridiculous energy
density as compared to xhat is needed to melt iron.
please learn what a
density is!
Again sorry but i cannot find any way to avoid a thermitic reaction just from the evidence of molten iron spheroid production as shown in their photographs. This is crucial and conclusive even if all the rest of the article were not conclusive. And this is why , when i couldnt obtain the same reaction my first conclusion had to be that it is my chips that deactivated by heat or humidity or aging...because the only other way out of this would be to accuse the authors of complete falsification of their data!
I admit i did not know that fly ash could be a large source of iron microspheres. But now i see another issue: a very significant fraction of these microspheres are essentially Fer + Al + O microspheres (i have checked this myself). Why so many of them have this signature ? And how this Al + O alloy could have formed ? you have to reach the Alumine fusion T which
is 2050°C when you burn your coal for that: significantly higher than 1500°C
to fuse iron. If not, a piece of alumina will remain at the surface of the iron liquid particle and you will not get a smooth spheroid.