NIST allowed the fires to burn for four hours in one place, when they usually burn out in no more than an hour, and they did not have beam temperatures above 600 degrees C.
ARUP's analysis used relatively high air temperatures for a full hour of 700 to 800 degrees C and showed steel temperatures up to 700 degrees C, but only for upper flanges of the beams and only for a short peak period. I have every confidence that the Weidlinger 859 degree C beam temperature claim would be knocked down significantly if it was contested.
Typical office fires generate more than enough heat to weaken structural steel. There are types of steel lose 10% of their strength at 450 C, and 40% at 550 C'. At temperatures above 800 C ( 1475 F), it has lost 90% of its strength.
The steel structures of WTC 1, WTC 2, and WTC 7 were subject to high-stressed load effects due to differential heating of their steel structures and structural load redistribution.
WTC 1, WTC 2, and WTC 7 suffered major impact damage that resulted in structural load redistribuition in locations where fires raged out of control, which further weakened their structures whereas structural loads continued to be redistributed as structural weakening progressed due to uncontrolled fires and differential heating. In other words, it was just a matter of time before the collapse sequence commenced for each of those buildings and structural buckling observed on the exterior of WTC 1, WTC 2, and WTC 7 were clear indicatiors that their structures were slowly being compremised by the combined effects of fire, impact damage, differential heating and structural load redistribution.
To make my point, WTC 1 and WTC 2 began their collapse seqences at the impact points. Any explosive or thermite placed in those locations would have been detonated or rendered ineffective, yet no secondary explosions were observed nor heard from impact to collapse and no evidence of demolition hardware or explosives was ever found within the WTC rubble.
In the case of WTC 7, once again, WTC 7 tilted toward the south in the final seconds of its collapse due to major impact damage from WTC 1. Fires raged for almost 7 hours in WTC 7 after major impact danage was incurred, yet no secondary explosions were observed or heard nor detected by seismographs. Had explosives been placed and detonated on their steel structures, shock signals would have been generated and sent into the ground whereas the signals would have been detected, yet no such signals were received by seismographs.
Let's look at it this way, you place your ear on one end of a steel beam and someone slams a hammer at the opposite end of the beam. The sound you hear is an example of what seismographs would have detected had explosives been detonated and for explosives for be effective against steel structures, the steel structures must first be pre-weakened and cutter charges and explosives must firmly be placed on the steel structures, otherwiise, the blast waves will simply flow around the steel beams. When you imply that explosives were used to bring down WTC 7 without evidence, that is an example of someone banging on a steel beam with a hammer, but producing no sound.
To sum it up, the claim that CD explosives were used to bring down the WTC buildings is simiply absurd and unfounded. Now, what can you tell us about the steel in the following photo?
Distorted Steel
http://www.911memorial.org/sites/al...og/images/TwistedWTCSteel1-e1275663221221.jpg
.