Miragememories
Banned
"...MM fully supports the Harrit et al paper and it's conclusions of thermite, but steadfastly refuses to agree with the authors and their analysis that samples a,b,c and d in Figs 7 & 8 are the same material."
Thank you for making your question more clear.
I have no disagreement with Figs 7 & 8. The 2009 Bentham paper properly identifies them. They show XEDS spectra and BSE images for 4 red chips. Each of these red chips were selected as 'chips of interest' and their a-d designation tells us the geographical location at which their parent 9/11 WTC dust was found.
"The claim that Millette has the wrong chips is obviously wrong and disingenuous too, it obviously implies that Millette doesn't know what he's doing and cannot see that his data doesn't match Harrit et al, except of course his data does match Harrit et al because he used Harrit et al's paper as a basis for his criteria in ensuring he had the right chips to analyse.[/i]"
Now you are getting to the real issue.
I am absolutely sure than Dr. Millette knows exactly what he is doing.
There is a case that can be made that Dr. Millette never fully read the 2009 Bentham paper.
And as a result of not taking advantage of what Dr. Harrit et al learned during early testing of the 'chips of interest', Dr. Millette worked from a much larger cache of 9/11 WTC dust red chips than necessary.
Un-ignited 'chips of interest' would have existed in Dr. Millette's isolation pile but their numbers would have been few compared to the volume of primer paint chips that would have been encountered.
Certainly Dr. Millette would have realized after his magnetic extractions that he had a lot of red chips matching the visual description provided by Dr. Harrit et al.
But his only criteria for selecting his chips of interest for further analysis, was that they were attracted by a magnet and that they had an EDS Al-Si-Fe spectrum.
Your list of comparisons certainly reflects an effort to show that Dr. Millette successfully matched the 2009 Bentham paper 'chips of interest'.
But only the two sides involved in the research of these chips can argue for or against the credibility of your list.
The fact is, the Bentham paper authors are not in agreement with Dr. Millette's unpublished convention paper findings.
They believe Dr. Millette had the misfortune of selecting the wrong 'chips of interest' from a large pile of possibles.
I am not saying that Dr. Millette's methods are faulty, but results speak louder than his words.
It is clear that Dr. Harrit et al had to seek out the chips of interest. That attraction by a magnet and a EDS Al-Si-Fe spectrum did not guarantee a 'chip of interest'.
As Dr. Harrit said, potential red chips were randomly selected and subjected to a number of tests before they were ignited in the DSC. The scientists could not be certain they had a true 'chip of interest' until they ignited it and examined the residue.
But they had the pre-DSC test results of every red chip used, thermitic or not.
For those red chips that proved to be thermitic, they just looked back over the pre-ignition data to obtain greater knowledge about what 'tells' pointed to a possible 'chip of interest'.
Red was a tell.
Magnetic attraction was a tell.
The Resistivity test was one of those 'tells'. They found that the 'chips of interest' had dramatically low resistance readings (~10 ohms).
With the Resistivity test, they discovered that chips that were primer paint had very high resistance readings (~100,000 ohms).
We can argue over chips 'a-d' forever and get no where.
My point is, there were a lot of red chips that were indeed very similar to the 'chips of interest' but while seemingly identical, they did not behave identically when ignited.
But what cannot be argued forever, is why any red chip found in the 9/11 WTC dust would leave iron-rich microspheres in its residue after ignition, where none previously existed.
Dr. Harrit et al have published there testable proof of thermite.
The only way we can tell if 'the emperor has clothes on' is to reproduce the test that lead to the thermite finding and start the discussion from there.
Dr. Millette knows it and you know it.
MM
, and over three orders of magnitude in the formulations that contain ferric oxide! (I assume it's Fe+3; the table merely says "iron oxide", which isn't at all specific, given the many, many forms of oxides of iron.)