This isn't a rigorous use of the word energy. If my center of mass is stationary, I'm not putting energy in. I am doing something that keeps the energy the same. That's not the same as putting energy in.
You
are putting in energy. The belt is taking energy away from you (transporting you downwards) and to stay at the same elevation you need to replace that energy by essentially walking back up.
The example is a box sitting on a table. If the table didn't stop the box from falling, it would lose potential energy and (temporarily) gain kinetic energy. The table doesn't put energy into the box to keep it stationary. It exerts a force opposite the force of gravity which keeps the potential energy the same and the kinetic energy zero.
However, that is not the same as the inclined belt.
Neither the table nor the box does any work.
Because the system is stationary. Take a different situation: A hovering helicopter. As it stays the same hight, it should need no energy, and the reason it does in fact consume energy is because it uses a somewhat inefficient method (essentially pushing down air). However, if you place the helicopter in a down-draft (e.g. from another helicopter above), you will need more energy to hover.
Where I lose energy on the treadmill is from moving my legs to remain stationary. This gives my legs kinetic energy, and expends chemical energy.
On a flat belt, you should ideally not spend any energy, but because walking is somewhat inefficient you still do. Just like the helicopter.
But it puts no net kinetic or potential energy into me as a whole, since my velocity and height remain the same.
On the inclined belt, the belt transports you down. It takes potential energy away from you, and inaddition to the energy you spend walking, you must also replace that potential energy.
So my argument is that yes, I lose energy on the treadmill. Yes, that is due to exerting forces on the belt. But when I increase the incline, it only makes it a little harder to lift my legs, but I don't have to do all the extra work to increase my potential energy like I would on a real slope.
Wrong. In essence, the situation is exactly as on a real slope. The reason it may not feel as hard is probably that a 10-15 degree slope is not really that steep for walking, plus you have no air resistance.
I am going to, but I will not try to move. I will try to remain stationary. If that's less work than climbing stairs, then I'm right about the potential energy thing.
Staying in the same place on a downward escalator is the same as climbing stairs. (sans air resistance)
On where the energy goes: Threadmills and escalators are driven by electric motors. Most electric motors are are intrinsically fixed speed; if you try to push them faster, they will act as generators and produce energy, which will be dissipated in various ways.
Hans