Here are some of my favorites from NIST that I found on
http://www.physics911.net/stevenjones
The focus of the Investigation was on the sequence of events from the instant of aircraft impact to the initiation of collapse for each tower. For brevity in this report, this sequence is referred to as the “probable collapse sequence,” although it does not actually include the structural behavior of the tower after the conditions for collapse initiation were reached…(NIST, 2005, p. 80, fn. 12)
The results were a simulation of the structural deterioration of each tower from the time of aircraft impact to the time at which the building became unstable, i.e., was poised for collapse. …(NIST, 2005, p. 142)
Review of videotape recordings of the collapse taken from various angles indicates that the transmission tower on top of the structure began to move downward and laterally slightly before movement was evident at the exterior wall. This suggests that collapse began with one or more failures in the central core area of the building. (FEMA, 2002, chapter 2) NIST does not comment on this.
“The jet fuel probably burned out in less than 10 minutes.” –Sunder NIST
Then…
NIST notes that office materials in an area burn for about 15-20 minutes, then are consumed away (NIST, 2005, pp. 117, 179).
Of the more than 170 areas examined on 16 perimeter column panels, only three columns had evidence that the steel reached temperatures above 250ºC… Only two core column specimens had sufficient paint remaining to make such an analysis, and their temperatures did not reach 250 ºC. … Using metallographic analysis, NIST determined that there was no evidence that any of the samples had reached temperatures above 600 ºC. (NIST, 2005, pp. 176-177;.)
Both WTC 1 and WTC 2 were stable after the aircraft impact, standing for 102 min and 56 min, respectively. The global analyses with structural impact damage showed that both towers had considerable reserve capacity. This was confirmed by analysis of the post-impact vibration of WTC 2… where the damaged tower oscillated at a period nearly equal to the first mode period calculated for the undamaged structure. (NIST, 2005, p. 144)
At any given location, the duration of [air, not steel] temperatures near 1,000oC was about 15 min to 20 min. The rest of the time, the calculated temperatures were near 500oC or below.” (NIST, 2005, p. 127)
The Investigation Team then defined three cases for each building by combining the middle, less severe, and more severe values of the influential variables. Upon a preliminary examination of the middle cases, it became clear that the towers would likely remain standing. The less severe cases were discarded after the aircraft impact results were compared to observed events. The middle cases (which became Case A for WTC 1 and Case C for WTC 2) were discarded after the structural response analysis of major subsystems were compared to observed events. (NIST, 2005, p. 142)
The more severe case (which became Case B for WTC 1 and Case D for WTC 2) was used for the global analysis of each tower. Complete sets of simulations were then performed for Cases B and D. To the extent that the simulations deviated from the photographic evidence or eyewitness reports [e.g., complete collapse occurred], the investigators adjusted the input, but only within the range of physical reality. Thus, for instance,…the pulling forces on the perimeter columns by the sagging floors were adjusted… (NIST, 2005)
the pulling forces on the perimeter columns by the sagging floors were adjusted” (NIST, 2005, p. 142)
NIST contracted with Underwriters Laboratories, Inc. to conduct tests to obtain information on the fire endurance of trusses like those in the WTC towers…. All four test specimens sustained the maximum design load for approximately 2 hours without collapsing… The Investigation Team was cautious about using these results directly in the formulation of collapse hypotheses. In addition to the scaling issues raised by the test results, the fires in the towers on September 11, and the resulting exposure of the floor systems, were substantially different from the conditions in the test furnaces. Nonetheless, the [empirical test] results established that this type of assembly was capable of sustaining a large gravity load, without collapsing, for a substantial period of time relative to the duration of the fires in any given location on September 11. (NIST, 2005, p. 141