[Closed]Active Thermitic Material Discovered in Dust from the 9/11 World Trade Center

Status
Not open for further replies.
Any chance of an english translation of the french PDF?

TAM:)

Of course, his conclusions are the same than Jones's...
So you don't need translation !!!:):):)

S1 and S2 are two diferent samples...

First he study microspheres (slides 6-8)
then dust without microsphere (9)

and finally chips...

Slide 14-15 is for the red layer (different points)...
Slide 16-17-18 for the gray layer (different points)...

and the conclusions....
 
Of course, his conclusions are the same than Jones's...
So you don't need translation !!!:):):)

S1 and S2 are two diferent samples...

First he study microspheres (slides 6-8)
then dust without microsphere (9)

and finally chips...

Slide 14-15 is for the red layer (different points)...
Slide 16-17-18 for the gray layer (different points)...

and the conclusions....
And T.A.M. certainly wouldn't have gotten much out of me.

Je voudrais une kilo de pomme sil vous plait! :blush:
 
Pardalis, how about this,

- Présence de microsphères confirmée
●- Microstructures de surface : S1 couche floconneuse, S2 surface propre
et nue: écailles et ondulations
●- S1 & S2 : Microsphères essentiellement en Fer et Fer oxydé, signature
Fer-Alu nette dans certaines, peu significative dans la majorité (l'Alu est
expulsé par une réaction de thermite).
●- S2 : Séries de raies Fe, Ni, Zn, Mg, Al énigmatiques. Ni est un élément
très rare dans la poussière (USGS)
●- S1 : Une microsphère de Fer pur i.e. non oxydé. Pic du Fer à basse
énergie absent ! : écrantage par une couche superficielle gazeuse
(éléments légers non détectés par le spectro) prise dans les flocons et
absorbant les X de basse énergie (?)

-----

●Présence de chips rouge et constituents des couches à peu près
confirmés : accord avec résultats détaillés de S Jones et collaborateurs
●
● - Couche rouge : Fe, O, Al, Si, C
●Oxyde de Fer domine largement sur le Fer: couleur rouge vif plutôt que
rouille! Couche isolante (brillante au spectro) ==> mélange homogène de
l'oxyde de Fer avec les éléments non conducteurs Al, Si. Faible variabilité
(aspect, couleur, spectre ) ==> mélange homogène à une échelle
inférieure au micron.
● - Couche grise conductrice : Fe, O parfois traces de Mn et Cr .
●Compatible avec de l'acier structurel. Couleur sombre: Fer peu oxydé.
●
●Frontière très nette entre les couches ==> pas par hasard !

------

●Interprétation de S Jones et collaborateurs confirmée.
●
●Observation compatibles avec l'hypothèse de nanothermite, matrice de Si
et particules d' Oxyde de Fer (rouge) et Al, ayant été appliquée sur l'acier
des colonnes. Carbone : probable résidu organique des solvants du solgel
(isopropanol, epoxyde organique).
●
●La méthode sol-gels n'est pas seulement idéale pour gagner en énergie
mais aussi pour un dosage/contrôle précis de la puissance de la réaction.
L'utilisation sous forme de spray est connue ==> la couche nanothermitique
a sans doute permis de chauffer efficacement les colonnes
d'acier. La réaction a produit le Fer liquide. Les explosions l'ont dispersé
en microsphères observées.

TAM:)
 
Well, I'm hoping that detailed pictures will show more than just layers. E.g., what about the eveness of layers? Come to think of it, please make paint chips via both brushing and spray painting. I find it hard to believe that brushed on paint will have even layers, and easy to believe that spray painted surfaces will



Thank-you. I just sent Professor Jones and email requesting the exact paint type, but as he didn't directly reply to my last email (though cc'ing me on others), I'm a little doubtful that I'll get a direct answer. We'll see.
You can also ask him why he failed to put that crucial information in his paper and whilst you're at it slap his wrist for such a basic error, it's unforgivable for someone of a post graduate level.
 
Of course, his conclusions are the same than Jones's...
So you don't need translation !!!:):):)

S1 and S2 are two diferent samples...

First he study microspheres (slides 6-8)
then dust without microsphere (9)

and finally chips...

Slide 14-15 is for the red layer (different points)...
Slide 16-17-18 for the gray layer (different points)...

and the conclusions....

ahhh...

well perhaps don't bother then Pardalis....If he is as ignorant and obtuse as Jones, It will likely just be more biased, poorly conducted science.

TAM:)
 
.....9/11 experts....
That's an oxymoron. Samples a-d from Jones paper are clearly flaked off iron oxide from steel with some red paint attached. We now have SEM photos showing the steel, it's oxide and the paint red layer all in detail. Jones never shows us the underside of his chips - Why not?

Jones et al and the truth movement do not understand that Jones' paper is self debunking! Jones proves that one of the sources of iron-rich micro-spheres is burnt paint.

Lets see if we can get an answer from the great Galileo - master scientist.

Why do we find Silicon in the thermite?
 
Last edited:
Can google or any other translator, translate a PDF file??

TAM:)

Here's what I started with.
Analyse indépendante de poussière
du WTC à Marseille
Afin de donner plus de poids aux découvertes de Steven Jones et ses
collaborateurs en particulier la présence de nanothermite n'ayant pas réagi dans
la poussière du WTC, il importait que celles-ci soient indépendamment
corroborées par des analyses indépendantes.
Les microphotographies et spectres ici présentés ont permis de retrouver
certaines des caractéristiques importantes qui suggèrent fortement la présence de
thermite nanocomposite. Origine et description des échantillons:
http://www.darksideofgravity.com/11 Septembre 2001.html#sample
Ce sont les tests cruciaux que je n'avais pas les moyens d'effectuer en particulier
la calorimétrie à l'ignition des chips rouges et l'usage de solvants pour isoler et
identifier les différentes composantes du mélange thermitique qui apportent la
démonstration définitive de sa nature:
http://www.darksideofgravity.com/11 Septembre 2001.html#publi
Here's what I got, using google.
Independent analysis of dust
WTC in Marseille
To give more weight to the findings of Steven Jones and his
employees in particular the presence of unreacted nanothermite in
dust from the WTC, it was important that they are independently
corroborated by independent analysis.
Photomicrographs and spectra presented here reveal
some of the important features that strongly suggest the presence of
nanocomposite thermite. Origin and description of samples:
http://www.darksideofgravity.com/11%% 20 September sample # 202001.html
These are the crucial tests that I could not afford to carry out particular
calorimetry to the ignition of red chips and the use of solvents to isolate and
identify the different components of the mixture thermite which provide
final demonstration of its kind:
http://www.darksideofgravity.com/11%% 20 September publi # 202001.html

Seems ok to me.
 
sunstealer said:
Lets see if we can get an answer from the great Galileo - master scientist.

Why do we find Silicon in the thermite?
Breast implants??

9/11 was a FEMBOT job!

1418949de6c1c256b3.bmp
 
Pardalis, how about this,TAM:)

Here goes for nothing:

-Presence of microspheres confirmed
- Surface microstructures: S1 “flaky” layer, S2 clean surface: scales and waves
- S1 and S2: Microspheres essentially made of Iron and oxydised Iron, clear “Iron- Aluminum” signature in some, less so in most (Aluminum is expelled through reation with thrermite)
- S2 : series of “enigmatic “strata of Fe, Ni, Zn, Mg, Al. Ni is very rare in dust (USGS) (don’t know what USGS means)
- S1 : A microsphere of pure Iron i.e. non oxydized. No peak of Iron at low energy is observed. “écrantage” (no idea how to translate “écrantage”, “écran” means “screen”, so I guess “screening”?) by superficial layer of gas (light elements not detected by spectrometer) taken in flake samples which absorbed the Xs at low energy (?)

- Presence of red chips and “constituents” (?) of layers for most confirmed: confirms Jones’ data.
- Red layer: Fe, O, Al, Si, C
- Iron Oxyde dominates on the Fe: bright red color rather than rusty color. Layer consistant (bright at the “Spectro”) ==> homogenous mix of Iron Oxyde with non conductive elements Al, Si. Low variability (general aspect, color, spectrum)==> homogenous mix lower than one micron.
- Grey conductive layer : Fe, O sometimes traces of Mn and Cr .
- Compatible with structural steel. Dark color: Fe a little oxydized.
- Clear edge between the strata==> not by chance!

- Interpretations of Jones and collaborators confirmed.
- Observations compatible with nanothermite hypothesis, matrix of Si, and Iron Oxyde particles (red) and Al, were applied to steel columns. Carbon: probably organic residue of “sol-gel” solvants (don’t know what “sol-gel” is in English, literally it would be “ground-frost”?)(isopropanol, organic epoxyde).
- The “sol-gel” method isn’t uniquely ideal to gain energy but also to control the force of reaction.
- the use of spray on is well known ==> The nanothermite layer probably was used to heat the steel columns. The reaction produced liguid Iron. The explosions scattered them in microspheres.
In bold what I couldn't translate
 
Last edited:
Pardalis, how about this,



TAM:)

Here ya go.
Quote:
- Presence of microspheres confirmed
● - Microstructures of surface layer flaky S1, S2 clean surface
and naked and scaly ripples
● - S1 & S2: microspheres mainly iron and oxidized iron, signature
Alu-iron net in some marginally significant in the majority (aluminum is
expelled by a thermite reaction).
● - S2: Series rays Fe, Ni, Zn, Mg, Al enigmatic. Neither is a
very rare in the dust (USGS)
● - S1: A True Iron microsphère ie non-oxidized. Pic du Fer low
energy away! : Shielding by a gas layer
(light elements not detected by the spectrometer) taken in the flakes and
absorbing low-energy X (?)

-----

● Presence of chips and red layers are almost
confirmed agreement with detailed results of Jones S et al
●
● - Layer red: Fe, O, Al, Si, C
● Iron Oxide dominant on Iron: bright red rather than
rust! Insulating layer (the shiny spectro) ==> a homogeneous mixture of
Iron oxide with non-conductive elements Al, Si Low variability
(appearance, color, spectrum) ==> mixing at a scale
below the micron.
● - gray conductive layer: Fe, O sometimes traces of Mn and Cr.
● Compatible with structural steel. Dark Iron little oxidized.
●
● clear boundary between layers ==> no coincidence!

------

● Interpretation of S Jones and collaborators confirmed.
●
● Observation compatible with the hypothesis nanothermite matrix Si
and particles of iron oxide (red) and Al, was applied on steel
columns. Carbon probable residue of organic solvents SolGel
(isopropanol, organic epoxide).
●
● The sol-gel method is not only ideal to save energy
but also for a mix / control over the power of the reaction.
Use as a spray is known ==> layer nanothermitique
has undoubtedly helped to effectively heat the columns
steel. The reaction produced a liquid iron. The explosion scattered
observed in microspheres.

See Pard beat me.
 
Last edited:
A clear area between strata is consistant with paint. I know that when I use certain types of paints on my model armor, especially if I am using flat latex, the collors look a little different when wety or dry as pigments migrate to thje surface and particulates settle out of the liquid vehicle.
 
I'm still at a loss to explain why NIST didn't check for thermitic material in the debris during the course of their investigation. Surely they had the means to arrive at the same conclusions arrived at by Jones et al. Perhaps they didn't want to confirm their underlying suspicions? Afterall, weren't some NIST scientists actually involved in the nano-technology research back in the nineties for the industrial military complex? Talk about turning a blind eye.:covereyes
 
which means that anyone stripping paint with a blow torch whether it be at home or cleaning the Brooklyn Bridge or whatever, if they are stripping red paint they will be producing iron rich microspheres.
Incidently, am I mixing things up, or wasn't the lady that found the dust in her apartment, sharing her apartment/studio with an artist that worked primarily with metal art?

I could have sworn I read that about the first time these micro spheres was brought up. :confused:
 
If there was a conspiracy to doctor the tape, someone would have talked by now.

They don't need to. One man could do it himself, and he did it so poorly that any one with the sense God gave earthworms can see it is faked.
 
Status
Not open for further replies.

ISF - Join now!

Every member here is approved by hand. No bots, no spam, just people who care about evidence and honest debate.

Membership is free!

Create your free account

Back
Top Bottom