Wrong
Fire math
http://www.firefightermath.org/index...d=31&Itemid=45
By rounding up to 0.5 from 0.434, friction and head losses due to the hose itself are taken into account, and
no additional calculation is needed. In the field, the 0.5 pounds per square inch head loss is therefore used. This approximation not only eases calculations,but
is more realistic to use in the field.
So, you're under the impression that because there is a pumper available, (which it most likely WASN'T do to FDNY priorities) that no matter what, they could have fought the fire.
Your assumption is assinine at best. I know this is going to be very confusing for you, but let me spell it out for you.
NOT ENOUGH WATER. It doesn't matter if it is in THEORY possible, (which it WASN'T), because of the fact that they only had a limited amount of water to start with. Why is that? Because the FDNY was using fire pumps to suction water from the Hudson River. You MUST account for the loss becuse you're using the pumps for drafting operations. This changes the dynamics completly. You also have to account for the many wyes that were in the system at the time. In no way shape or form could the head pressure overcome the lack of water. NOT ENOUGH WATER.
Why do you think highrise buildings use standpipe systems? Is it because you think it looks cool on blueprints? Or maybe it's because you think that fire safety engineers like putting useless systems into the design of buildings, like you seem to think that SFRM is?
Here, let me explain it to you.
When you stretch out 100' of hose, you lose head pressure because of the friction loss of that hose. Now, stretch out 400' of 2" line, and you're going to lose most of your ability to fight a fire. Throw a bunch of bends into it, while traveling upstairs, and you may as well have a bucket brigade.
Don't think that I don't know firefighter math. I teach it. I have studied it for many years. I know it forwards and backwards. I can run circles around you when it comes to firefighter math. You're still trying to figure out what a drafting operation is.
Irrelevant to the point which is:
No, it most certainly is NOT irrelevant. The FDNY couldn't care LESS about an unoccupied building that was UNSAFE to enter, when they have hundreds of their own men missing from the collapse. Not to mention the unknown amount of citizens that lay dead or dying in the rubble that was once 1&2 WTC. It's called triage. Take case of the IMPORTANT stuff first, then deal with the rest.
Your ignorance of the FDNY and every firefighter's mission is staggering. We don't care about property. We care about saving lives.
You did not read the information at the URL I posted. It is referring to pump trucks:
Pump Mounting on Apparatus a. Mid-ship (middle) – 2 ways
i. Between road transmission and rear axle in line with drive shaft (most common)
ii. Ahead of clutch and transmission with flywheel and power take off. This type allows for direct engine power to pump transmission connection. It allows for driving and pumping simultaneously.
http://home.honolulu.hawaii.edu/~jkemmler/chapter4.htm
I know exactly what a pump truck is. They usually carry the following.
1 Driver/engineer
1 Officer
2-4 firefighters
Usually consist of a 500-1000 gallon tank for a reserve, and can flow anywhere between 1000-5000 gpm depending on the setup.
Also usually carry anywhere between 1-2000 feet of various hoses, including 200' of 5" main pump line, 800' of 2' or 1 1/2" handlines, and usually have a small booster line either mounted on the front bumper, or in a rear compartment with a 1" line for fighting small fires.
Don't think you can try to school me on firefighting. I'm in a whole 'nother league compared to you. You're still googling for drafting operations, while I am teaching Higbee Cuts to rookies. Go google that too.