bill smith
Part C nuust be utterly ruined by the meshing of part C and part A. Part A has it's braced giant upstanding core columns anchored in the ground offering their full and constant strain energy against all comers. The falling part C on the other hand, given that the upper and lower core colmns are offset from each other can only offer a sequence of weaker elements such as floor-to-column connections, floor trusses. concrete floors and so on. The constant SE of the upstanding columns will take these ghallenges one at a rime and destroy them over the whole width of the buildng.
Take a floor-to-column connection in part C. It is still attached to a column in part C. It meets the upstanding giant A column. Between the descending piece of core column and the upsatnding column the connection is smoothly stripped of the C column . Then then same happens with the next component/element in line etc etc.
While C may damge A significantly it will be clear that A damages C far more. And C is much smaller than A and can afford the attrition less. A destroys C and collapse is arrested.
(Instructions in back of nano-thermate can)
Notes Apply What Is Proper Way To Put Material:
Your columns are focal point of building. Be sure that columns painting meshing techniques and choice of most flattering to your surreptitiouse purpose when reinstaling.
With color C create the illusion new shapes and discrete sizes. Always mind light colors highlight errors
and dark colors enter in the suspicious of authorities especialy paint not dry to touching.
Recede over when approached by questioners so as to disguise the plaster of reapplication in time for
drying in two coat . It's Aluminum powder color A column shadows be convenient do not hurry when surprised by owner of office says "Hey what you doing in my office" reply with singles or coordinated duos, or quads. A
tested reply assurance OK and go on.
Try to find far away columns that are hily misterious. Simply put, you want material you see in
container to not see after aplycation. When aplying material sweep the stroke over entire area from
illusion edged to neck widow. This sweep will be base application first slowly and is to complete job
reduce strain energy tender forearms. It will prevent creasing etc etc.
After plaster work dry applying base coat, apply second wait dry. Remember plaster removal first steel
paint on upper parts tardy not other way. Its part that most error apply. No.
Third coat be added. Use a deep, dark depth. Apply this along the line, and at the outer drawers
emphasizing the crease of the corner at steel lips. Arrest attrition ,this is more defined receptacles.
How you apply final coat help smaller, wider set or closer together. Key is blend well that attention
still away from recent work arrested not "just applied".
Install ceiling tile.
There done.
___________________________________________________________
"`Contrariwise,' continued Tweedledee, `if it was so, it might be; and if it were so, it would be; but as it isn't, it ain't. That's logic.' "
- Alice in Wonderland