[Closed]Active Thermitic Material Discovered in Dust from the 9/11 World Trade Center

Status
Not open for further replies.
Playing with Platelets, part 2

There may be other options. E.g., you can buy silicon in nano-scale platelet form.


You can deposit Al onto silicon via sputtering.
( and perhaps other methods of physical vapor deposition? not sure if this means elemental Al )


As for the motivation to do so, I have absolutely no idea about cost (and absolutely no intention to research it), but aside from that, referring to "MODELING THE MELT DISPERSION MECHANISM FOR NANOPARTICLE COMBUSTION"

Another speculation as to platelets vs. spherical:

The MODELING thesis says:

A combination of increased oxide shell formation temperature and increased oxide shell strength could be used to maximize the flame velocity in particles with increased relative particle size.

Besides packing more Al per unit volume, a platelet morphology, by minimizing the ratio of Al to Al oxide, might result in not just more energy, but relatively less power (i.e., a slower reaction). For one thing, I expect the oxide layer to break near the platelet edges (this is an uneducated guess, I hasten to add), and to do so under less pressure than would be required to break an oxide layer of equal thickness in the spherical case. * This would tend to negate the dispersion melt mechanism as a contributor to flame propagation. Hence, your nanothermite will have it's power profile shifted back towards that of the micron-thermite type, while simultaneously generating more total energy.


If you look at Fig. 1 of MODELING, you can see that Aluminothermics already have dramatically superior energy density (per unit mass) than high explosives, but the energy density, per unit volume, of Al/Fe2O3 is only about 40% greater than high explosives. You can't change the inherent mass of reactants, but you can fiddle with the density. If you simultaneously increase the energy per unit volume, while slowing down the reaction, you can end up with a hotter, but quieter "explosion".


* from MODELING:
The pressure inside the Al particle causes tensile hoop stress (σh) in the oxide shell. Due to the small thickness of the oxide shell (1 – 8 nm), it is almost defect free and therefore its ultimate strength (σu) approaches the theoretical maximum strength of alumina (σth) estimated at 11.33 GPa [11].
 
Nano-technology may be a recent development but nanoparticles have been used for thousands of years. They were used by 9th century Mesopotamian artisans to achieve a glittering effect on the surface of pots.

Fail.

Sure....stained glass was made the same way..not that they knew the technicalities of what they were doing- just that it worked.

But this line from the Jones paper indicates something else altogether.

''After igniting several red/gray chips in a DSC run to
700 °C, we found numerous iron-rich spheres and
spheroids in the residue''

Man this stuff is Thermite....get used to it, 9/11 was an inside job.
 

It was Danish TV indeed, in a sort of British Newsnight equivalent. The ´troofers´ are understandably jubilant:

http://www.911blogger.com/node/19805#comment

This is a real first MSM breakthrough, not counting the prime time live japanese coverage of a parlamentarian stating his doubts about the OCT in parlament.

Beginning of the end of the OCT indeed.
 
Man this stuff is Thermite....get used to it, 9/11 was an inside job.

why..because YOU say so? its that simple huh?

Look out everyone!! Bill Smith says 9-11 was an Inside Job!! We better all cancel our JREF accounts, the mystery has been solved.

=)
 
Last edited:
Hey. Bill Smith says it's an inside job. Run for the hills folks, our days are numbered!
 
Sure....stained glass was made the same way..not that they knew the technicalities of what they were doing- just that it worked.

But this line from the Jones paper indicates something else altogether.

''After igniting several red/gray chips in a DSC run to 700 °C, we found numerous iron-rich spheres and spheroids in the residue''

Man this stuff is Thermite....get used to it, 9/11 was an inside job.
Nope - 700°C is higher than the melting point of Aluminium - why aren't any of their samples showing globules of aluminium?

We know that independent analysis confirmed iron-rich spheres. Jones' paper proves that a source of iron-rich spheres is burnt paint.
 
''After igniting several red/gray chips in a DSC run to
700 °C, we found numerous iron-rich spheres and
spheroids in the residue''

Man this stuff is Thermite....get used to it, 9/11 was an inside job.


Care to explain this huge logic leap?
 
Nope - 700°C is higher than the melting point of Aluminium - why aren't any of their samples showing globules of aluminium?

We know that independent analysis confirmed iron-rich spheres. Jones' paper proves that a source of iron-rich spheres is burnt paint.

Dude, let it go. Bill Smith just said it was an inside job. We should take his word for it.

:D
 
I can hardly believe that most guys of your persuasion still say there is no need for a new and independent 9/11 investigation.

what.....lol...cough

what does that exactly mean?

Are you actually claiming that Jews should think that 9-11 was an inside job..because we are Jews? lolololol

oy vey.

your hole is now 9 feet deeper. I suggest you stick to the topic and not derail the thread into ethnic insults.
 
Last edited:
Nope - 700°C is higher than the melting point of Aluminium - why aren't any of their samples showing globules of aluminium?

We know that independent analysis confirmed iron-rich spheres. Jones' paper proves that a source of iron-rich spheres is burnt paint.

If I was you I'd be nore concerned about the presence of melted steel than the absence of aluminium.

As a scientist I don't think you can be serious about the burnt paint thing.
 
Last edited:
what.....lol...cough

what does that exactly mean?

Are you actually claiming that Jews should think that 9-11 was an inside job..because we are Jews? lolololol

oy vey.

your hole is now 9 feet deeper. I suggest you stick to the topic and not derail the thread into ethnic insults.

Lol. I am surprised. With a certain little moustache under your nose you might look a litle like somebody German who didn't like Jews. No offence intended btw.
 
Lol. I am surprised. With a certain little moustache under your nose you might look a litle like somebody German who didn't like Jews. No offence intended btw.

No, I have green/blue eyes. Hitler had brown eyes.

Nice ad hom by the way. Learn to attack the message, not the messenger.
 
But what did you mean by "people of your persuasion"?

Were you talking about skeptics here in general, or Parky specifically?
 
Oh no... I am being ignored the JREF circus ringmaster of moment. Whatever...

Anyone with serious materials analysis experience can see that your Kaolinite/Tnemec theory in nothing more than a weak hypothesis produced by rank amateur.


Hmm.. for any lurker it is quite clear the weak hypotheses and rank amateurism is on the side of the table where you and your fellow clueless, delusional dolts (*) are sitting, Czar of the dolts Jones included.

WTC was brought down by demolition. It's true, True, TRUE. Nothing could be more TRUE. And we have da Prooof. Layered stuff, Fe2O3, Al(something).. See ABSOLUTE proof.. termite! Proof.. and no it's not paint from NYU Stadium. ABSOLUTE SCIENTIFIC Proof, we'll tell yu!... Give me a break.

(*) And no, this is not an Ad Hominem, it explains a large volume of empirical data. It is therefore a scientifically correct conclusion
 
But what did you mean by "people of your persuasion"?

Were you talking about skeptics here in general, or Parky specifically?

he was talking about me. he is saying that a good Jew would be a Truther-Jew.

then he said I almost look like Hitler. nice huh?

:D
 
Status
Not open for further replies.

ISF - Join now!

Every member here is approved by hand. No bots, no spam, just people who care about evidence and honest debate.

Membership is free!

Create your free account

Back
Top Bottom